Subaru 1998 Legacy Owner's Manual page 168

J Repeat button (RPT)
Push the "RPT" button to repeat the piece of music being listened to. To
use this function, push the "RPT" button while the piece you want to hear
again is being played. "RPT" will be indicated on the display. When the
selection ends, the cassette player automatically rewinds to the begin-
ning of the piece and the selection begins again. To cancel the repeat
function, push the "RPT" button again. Until the repeat function is can-
celled, the same piece of music will be repeated indefinitely. The "RPT"
function may not operate properly under the following conditions:
D When the recording level is low.
D When there are long pauses in the middle of a selection.
D When the tape contains verbal material such as conversations.
D When the blanks between selections are shorter than five seconds.
D When there are no blanks between selections (live concerts, etc).
J Dolby NR button (
)
Press the " " button when playing tapes recorded using the Dolby NR
system*. The " " indicator will light up and high-frequency noise on
the tape will be reduced for clearer sound reproduction.
* Noise reduction system manufactured under license from Dolby Laboratories
Licensing Corporation. "Dolby" and double-D Symbol are trade marks of Dolby
Laboratories Licensing Corporation.
J Auto metal sensor
The cassette player automatically adjusts for metal or CrO tape.
2
J Metal tape indicator (MTL) (if equipped)
If metal or CrO tape has been inserted into the cassette slot, "MTL" will
2
be indicated on the display.
CLOCK FUNCTION
The radio has a built-in clock function that displays the time when the
ignition switch is turned either to "ACC" or "ON".
5-16