Rear Combination Lights - Subaru 1998 Forester Owner's Manual

Maintenance and service
3. Remove the bulb holder from the front turn signal light assembly by
turning it counterclockwise.
4. Pull the bulb out of the socket. Install a new bulb.
5. Set the bulb holder into the front turn signal light assembly and turn it
clockwise until it locks.
6. Set the front turn signal light assembly into the fender. Tighten the
mounting screw.
J Rear combination lights
HS0218 HS0219
1. Unlatch the rear combination light cover by pulling the knob. Open
the cover up.
2. Remove the bulb holder from the rear combination light assembly by
turning it counterclockwise.
3. Remove the bulb from the socket by pushing it and turning counter-
clockwise. Install a new bulb.
4. Set the bulb holder into the rear combination light assembly and turn
it clockwise until it locks.
5. Close the cover and latch the lock.
– CONTINUED –
10-53