Subaru 1998 Forester Owner's Manual page 132

J Program switching buttons (PROG)
When the program switching buttons ("
pressed at the same time during playback, the tape travel indicators will
switch and the player will begin playing back the opposite side of the
tape. The same mechanism is automatically activated when the end of
the tape is reached. This allows the opposite side of the tape to play,
providing continuous playback.
J Fast-forward button
To fast-forward the tape, press the "
direction to the tape travel indicator. To stop fast-forwarding, lightly press
the opposite side of the "
J Rewind button
To rewind the tape, press the "
direction to the tape travel indicator. To stop rewinding, lightly press the
opposite side of the "
J Stop and eject button (
When " " button is pressed, play back stops and the cassette tape is
ejected.
Before the ignition switch turn to the "OFF" position, eject the tape from
the player. Always make certain that you remove the cassette tape.
J Tape program sensor button (TPS)
Press "TPS" button during playback to return to the beginning of the cur-
rent selection or to skip to the beginning of the next selection. To use this
function, press the "TPS" button to turn on the "TPS" indicator. If the fast-
forward button is then pressed, the player advances the tape to the be-
ginning of the next selection and starts playing it. If the rewind button is
pressed instead, the player rewinds the tape to the beginning of the cur-
rent selection and starts replaying it. The "TPS" function may not operate
properly under the following conditions:
D When the recording level is low.
D When there are long pauses in the middle of a selection.
D When the tape contains verbal material such as conversations.
5-10
" or " " button.
" or "
" or " " button.
)
" and "
" or " " button in the same
" button in the opposite
" buttons) are