Replace A D-Link Cable In D-Link Groupers <= Ssr Task - IBM Power 775 Service Procedure

3.10 Replace a D-Link cable in D-Link groupers <= SSR Task
STEP 34 Remove a D-Link connector from the bundle assembly groupers at both ends of the cable. Pry apart the two tabs
at the upper left and lower right. This can be done with fingers (see Figure 10 and Figure 11). Once the two tabs
are pried apart, pull the cable connector out of the grouper.
Figure 18 Top view of grouper
STEP 35 Obtain a replacement cable that the same or longer length than the cable being replaced.
STEP 36 Label the new cable, to match the cable being replaced.
STEP 37 Plug the connector of the new cable into the grouper at one end.
STEP 38 Clean all connectors in the grouper. See
STEP 39 Remove the wrap plug and plug the grouper in by positioning the grouper for the D-Link optical connectors at the
proper row, inserting all connectors in the grouper into their respective D-Port adapter receptacles (see Figure 11),
and clicking them all into place.
STEP 40 Route the new cable along the bundle alongside the cable being replaced, to the other end of the bundle, removing
the old cable while re-doing hook-and-loop tape or vinyl tape along the way.
STEP 41 Plug the new cable's 2
STEP 42 Clean all connectors in the grouper. See
Power 775 D-Link Service Procedure
PN: 41U8487, EC N44172
Section 2.3.1.
nd
connector into the grouper at the other end.
Section 2.3.1.
23 of 27
Figure 11 Bottom view of grouper