STEP 6
In the window titled Identify LED, Select Enclosure select System Unit, Model F2C then click the Activate
LED button (see Figure 2). This will cause the CEC ID LED to flash, as well as the UEPO Panel of the frame.
STEP 7
Locate the frame. The UEPO Identify Amber Led (see Figure 3) should be flashing. If the LEDs are not flashing,
verify th e FRU via MTMS (machine type model serial number). The rack level MTMS is located on the face of
the UEPO (see Figure 3). Open the front and rear door of the frame.
Power 775 D-Link Service Procedure
PN: 41U8487, EC N44172
Figure 2 System Unit, Model F2C Selection – Activate LED
Identify
Amber
LED
MTMS
Figure 3 UEPO Identify LED location
13 of 27