Appliance Break-In; Heat Management; Ipi Battery Tray/Battery Installation - Majestic MERIDIAN PLATINUM Series Owner's Manual

G. Appliance Break-In
Initial Break-in Procedure
• The fi replace should be run 20 to 30 minutes continuously
on high.
• Turn the fi replace off and allow it to cool completely.
• Remove fi xed glass assembly. See Section 4.B.
• Clean fi xed glass assembly. See Section 4.B
• Replace the fi xed glass assembly and run three to four
hours continuously on high.
• Turn the fi replace off and allow it to cool completely.
• Remove fi xed glass assembly. See Section 4.B.
• Clean fi xed glass assembly. See Section 4.B.
• Replace the fi xed glass assembly and run continuously
on high an additional 12 hours.
This process cures the materials used to manufacture the
fi replace.
NOTICE! Open windows for air circulation during fi re-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
Majestic • DBDV36PLATIN, DBDV36PLATIL, DBDV42PLATIN, DBDV42PLATIL Owner's Manual • 2454-981 Rev. C • 3/17
12
H. Heat Management
Heat Output
This model has a variable burn rate which is controlled
by the FLAME HI/LO switch on the control module or
by using the command on the optional remote control,
if installed. The control module is located in the control
cavity of the appliance.
adjustment instructions.
If an optional fan is installed, the fan speed is controlled by
adjusting the speed control knob or using the command
on the optional remote control, if installed. If the rheostat
included in the optional fan kit is installed, turn the knob
clockwise to increase the fan speed and counterclockwise
to decrease the fan speed.
I. IPI Battery Tray/Battery Installation
The IntelliFire Plus system has a battery backup option.
TM
Battery longevity and performance will be affected by the
service temperatures of this appliance.
NOTICE: Batteries should only be used as a power source
in the event of an emergency such as an outage.
See Section 3.K for HI/LO