Troubleshooting; Possible Failures - Westinghouse WWF8025DQWA User Manual

9.

TROUBLESHOOTING

9.1 Possible Failures

Certain problems are due to lack of
simple maintenance or oversights, which
can be solved easily without calling out an
engineer. Before contacting your local
Service Centre, please check possible
cause of malfunction and solution listed
below.
Once the problem has been eliminated,
press the Start/Pause button to restart the
program. If after all checks, the problem
persists, contact your local Service Centre.
WARNING! Deactivate the appliance
before you do the checks.
Malfunction
The washing
machine does
not start:
The machine
does not fill the
water:
The machine
fills then
empties
immediately:
The machine
does not empty
and/or does
not spin:
Possible Cause
The door has not been closed. (code:
The plug is not properly inserted in the
power socket.
There is no power at the socket.
The Start/Pause (
been pressed.
The "Delay End" has been selected.
The Main supply is unstable.
(If code " " appears in the display.)
The water tap is closed. (code:
The inlet hose is squashed or kinked.
(code: )
The filter in the inlet hose is blocked.
(code: )
The door is not properly closed. (code:
The end of the drain hose is too low.
(code: )
The drain hose is squashed or kinked.
(code: )
The option "Rinse & Hold" has been
selected.
The laundry is not evenly distributed in the
drum.
Alarm Code:
The appliance does not fill with water
properly.
The appliance does not drain the water.
The appliance door is open or not
closed correctly. Please check the door!
The main supply is unstable. Wait until
the main supply is stable.
No communication between electronic
elements of the appliance. Switch off
and switch on again.
Water leaks inside the machine.
Please call Service Centre.
) touchpad has not
)
Solution
)
Close the door firmly.
Insert the plug into the
power socket.
Please check your domestic
electrical installation.
Press the Start/Pause (
touchpad.
If the laundry are to be
washed immediately, cancel
the "Delay End".
Wait until the main supply is
stable. Appliance will start
automatically.
Open the water tap.
Check the inlet hose
connection.
Clean the water inlet hose
filter.
) Close the door firmly.
Refer to relevant paragraph
in "water drainage" section
on page 31.
Check the drain hose
connection.
Press Start/Pause (
touchpad to drain the water
or select spin program.
Pause the machine and
redistribute laundry manually.
25
)
)