Pontiac 2005 Aztek Owner's Manual page 92

Canadian Owners: If you lose or damage your keys,
only a GM dealer can service PASS-Key
have new keys made. To program additional keys you
will need two current driver's keys (black in color).
You must add a step to the following procedure. After
Step 3, repeat Steps 1 through 3 with the second current
driver's key. Then continue with Step 4.
To program the new PK3
1. Verify the new key has PK3
2. Insert the current driver's key in the ignition and
start the engine. If the engine will not start, see
your dealer for service.
3. After the engine has started, turn the key to OFF,
and remove the key.
4. Insert the key to be programmed and turn it to ON
within 10 seconds of removing the previous key.
2-18
®
III to
®
key do the following:
®
stamped on it.
5. The SECURITY message will turn off once the key
has been programmed. It may not be apparent that
the SECURITY message went on due to how
quickly the key is programmed.
6. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the SECURITY message
comes on and stays on, you will be able to restart your
engine if you turn it off. Your PASS-Key
however, is not working properly and must be serviced
by your dealer. Your vehicle is not protected by the
®
PASS-Key III system at this time.
If you lose or damage a PASS-Key
dealer who can service PASS-Key
new key made.
®
III system,
®
III key, see your
®
III to have a