Factory Default Settings; Network Default Settings; Modbus Default Settings; Table 3.3 Network Default Setting - Atop MB52 Series User Manual

MB52XX Modbus Gateway
3.4

Factory Default Settings

3.4.1

Network Default Settings

The MB520X Industrial Modbus Gateway is equipped with one LAN interface with one default IP address. Its default
network parameters are listed in Table 3.3.
Interface
LAN1
3.4.2

Modbus Default Settings

The MB52XX Modbus Gateway comes with the following default Modbus settings.
Parameter
Modbus Master
TCP Settings
Modbus Slave

MB5201

MB5202
Other default settings are shown in the following table.
Parameter
Security
User Name
Password
SNMP
SysName of SNMP
SysLocation of SNMP
SysContact of SNMP
SNMP
Read Community
Write Community
SNMP Trap Server
Note: Press the "Reset" button on the front panel for 5 seconds (see Section 4.9.8 and Section 4.10), to restore the
MB52XX Series Modbus Gateway to the factory default settings.

Table 3.3 Network Default Setting

Device IP
10.0.50.100

Table 3.4 Modbus Default Settings

Table 3.5 Other Default Settings

User Manual
Subnet Mask
255.255.0.0
Default Values
TCP Master Mode: TCP Master
Port: 502
Mode: RTU Slave
Serial Configuration: RS-232, 9600 bps, 8 data bits, No
parity bit, 1 stop bit, No Flow Control, Buffer Disable
Default Values
admin
default
atop
Location
Contact
Disable (Unchecked)
Public
Private
0.0.0.0
Getting Started
Gateway IP
10.0.0.254
DNS
0.0.0.0