Comfort Controls & Audio Systems - Pontiac 1994 Bonneville Owner's Manual

Comfort Controls & Audio Systems
0
0
0
Electronic Climate
Control
(OPTION)
When the engine is cold, the "AUTO'
blower is delayed/reduced until warm
air is available. Immediately selecting
90°F farenheit will NOT get the car
warmer any sooner than selecting 75
"AUTO". The "DEFROST" blower
speed starts low to reduce windshield
fogging from any snow on the hood as
you start driving. The blower will
increase briefly after short stops when
the car had been turned off to reduce
any stuffy feeling.
The A/C will only work when the
outside temperature gets above 42°F.
A "click" noise means the A/C
compressor is turned on. Besides
cooling, this is used to dehumidify and
filter the air for inside the car.
A hot, sunny parking lot or city traffic
will cause the system to start
re-circulating A/C air for quicker
cooling. The system is more efficient
by cooling the air already inside the
car. EZ-Kool Glass is very effective in
filtering out the sun's heat.
0
The direction of the cold A/C air can
be controlled by adjusting the outlets
in the dash. Aiming them just over
your shoulder will benefit both front
and rear passengers. Back-seat
passengers can also redirect airflow at
the rear of center console.
The air conditioner compressor operates
in all "AUTO" setting positions, and in
%?
(Defrost) when the outside
temperature is above 42°F. When the air
conditioner is on, you may sometimes
notice slight changes in your vehicle's
engine speed and power. This is normal,
because the system is designed to cycle
the compressor on and off to keep the
desired cooling and help fuel economy.
TEMP: Sets the interior temperature you
want. The temperature you set will be
displayed on the digital screen.
Once you set the temperature, the system
will try to maintain the set temperature,
whether or not you are using the heating
or cooling controls. But if you set the
temperature for 60°F
(
16°C) or 90°F
(32"C), the fan will stay on "HI" speed
unless you select a different speed.
AUTO: To allow the system to
automatically control the temperature, air
Jistribution and fan speed:
1. Set the temperature you want with the
"TEMP" switch.
2. Press the "AUTO" switch.
EXT. TEMP:
Press to have the exterior
temperature displayed on the digital
screen (unless the system is off). Press
again to return to the inside temperature
setting. When the system is off, the
outside temperature will be displayed.
Use the following controls when "AUTO'
is not desired.
%
: Sets the fan speed. Press the top of
the switch to raise the fan speed, the
bottom of the switch to lower the fan
speed.
"F/C:
Press this to read the temperature in
degrees Fahrenheit or Celsius.
OFF:
Shuts the system off. The outside
temperature will be displayed. Air will
still flow through your vehicle if it is
moving. Also, the system will try to
maintain the temperature you set, but,may
...
116