Levelling The Appliance - LG WK2 S6 Series Owner's Manual

Using the Laundry Tub to Drain
1
Clip the end of the hose into the elbow bracket.
• Connect the elbow bracket
of the end of the drain hose. If the drain hose
is extended more than 10 cm beyond the
end of the elbow bracket, mold or
microorganisms could spread to the inside
of the washer.
2
Hang the end of the drain hose over the side of
the laundry tub.
3
Use the provided tie strap to secure the drain
hose in place.
within 10 cm
a
4 "
(10 cm)

Levelling the Appliance

Checking the Level
When pushing down the edges of the top plate
diagonally, the appliance should not move up and
down at all (check both directions).
• If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
• Check whether the appliance is perfectly level
after installation.
NOTE
• Timber or suspended type flooring may
contribute to excessive vibration and unbalance.
Reinforcement or bracing of the timber floor
may need to be considered to stop or reduce
excessive noise and vibration.
Adjusting and Levelling the
Feet
When installing the appliance, the appliance
should be aligned and perfectly level. If the
appliance is not aligned and level properly, the
appliance may be damaged or may not operate
properly.
1
Turn the levelling feet as required if the floor is
uneven.
• Do not insert pieces of wood etc. under the
feet.
• Make sure that all four feet are stable and
resting on the floor.
INSTALLATION
29