Installation Place Requirements - LG WK2 S6 Series Owner's Manual

Installation Place
Requirements
Before installing the appliance, check the following
information to make sure that the appliance
should be installed in a correct place.
Flooring
• To minimize noise and vibration, install the
washer on a level, solidly constructed floor
capable of supporting the appliance without
flexing or bouncing.
• The appliance must be installed on firm flooring
to minimize vibration during the spin cycle.
Concrete flooring is best, but a wood floor is
sufficient, provided it is built to FHA standards.
• The floor under the appliance must not slope
more than 2.5 cm from front to back or side to
side.
• Installing on carpeting and soft tile surfaces is
not recommended.
• Never install the appliance on a platform or
weakly supported structure.
Floor Installation
To ensure sufficient clearance for water inlet hoses,
drain hose and airflow, allow minimum clearances
of at least 2.5 cm at the sides and 10 cm behind the
appliance. Be sure to allow for wall, door, or floor
moldings that may increase the required
clearances.
Dimensions and Clearances
A
B
E
139.6 cm
77 cm
Dimensions and Clearances
C
D
E
F
G
Clearances
The following clearances are recommended for the
appliance.
• Additional clearances should be considered for
ease of installation and servicing.
• Additional clearances should be considered on
all sides of the appliance to reduce noise
transfer.
Installation spacing for Recessed
Area or Closet Installation
Description
A: Upper Ventilation
Opening
B: Lower Ventilation
Opening
INSTALLATION
10 cm
2.5 cm
70 cm
189 cm
2.5 cm
Dimension/
Clearance
2
310 cm
2
155 cm
15