Unpacking The Appliance - LG WK2 S6 Series Owner's Manual

WARNING
• Repairs to the appliance must only be carried out
by qualified personnel. Repairs carried out by
inexperienced persons may cause injury or
serious malfunctioning. Contact your local
authorised LG repairer.
• The power plug must be plugged into an
appropriate outlet socket that is installed and
grounded/earthed in accordance with all local
codes and ordinances.

Unpacking the Appliance

WARNING
• When installing this appliance, take adequate
measures to protect yourself, e.g. by wearing
protective gloves.
Lifting the Appliance Off the
Foam Base
* This feature may vary depending on the model
purchased.
After removing the carton and shipping material,
lift the appliance off the foam base.
• Make sure the tub support
the base and is not stuck to the bottom of the
appliance.
• If you must lay the appliance down to remove
the carton base , always protect the side of the
b
appliance and lay it carefully on its side. Do not
lay the appliance on its front or back.
*
* comes off with
a
Removing the Transit Bolt
Assemblies
To prevent the appliance from severe vibration and
breakage, remove transit bolts and retainers.
1
Starting with the bottom two transit bolts
use the spanner (included) to fully loosen all
transit bolts by turning them counterclockwise.
2
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
3
Install the hole caps.
• Locate the hole caps
accessory pack or attached on the back.
NOTE
• Save the transit bolts and retainers for future
use.
• To prevent damage to the appliance during
transport:
- Reinstall the transit bolts.
- Secure the power cord to the back of the
appliance.
INSTALLATION
included in the
b
17
,
a