Accent ACN1400-30 User Manual page 43

2. Align the holes in the reflector with the empty holes in the handle, port cover, or NuPoint module.
Important! Make sure the reflective shield is aimed downward toward the back of the device, as
shown in step 3 on the next page.
3. Insert the appropriate screws in the holes, as shown.
Handle:
Reflector side
pointing downward
NuPoint Module:
Reflector side
pointing downward
Port Cover:
Accent 1400 User's Guide
Insert the two
short screws
Insert the two
long screws
43