Table of Contents
Advertisement
To remove the bumper guards: Remove the mounting screws, pull the bumper guards off the corners,
and store the bumper guards and screws in a safe location in case you need them later.
Positioning or Removing the Stand
Do not carry the device by the stand. When carrying the device, use the handle or carry strap.
You can use the stand in either the closed or open position, or you can remove it completely.
Opening the Stand
The stand in the latched position provides a slight angle for viewing the screen when the device is sitting
on a flat surface. When the user needs an additional angle, extend the legs of the stand away from the
back of the device by doing the following:
1. Place the device face-down on a flat surface.
2. Snap thestand's bottom support loose from its latches on the back of the device.
3. Rotate the stand away from the back of the device until the legs latch into place.
Removing the Stand
If you do not want to use the stand, you can remove it from the back of the device. You can reattach it
at any time.
1. Place the device face-down on a flat surface.
2. Remove the screws from the holders at the end of each of the stand's legs.
3. Pull the holders free and put them in a safe place in case you need to use them later.
Loose holders could be a choking hazard.
4. Spread the legs apart to pull them out of the holes in the back of device.
5. Pull the stand free and put it in a safe place in case you need to use it later.
Important! If you reattach the stand, be sure to secure the legs with the holders to prevent
someone from pulling it loose accidentally.
Accent 1400 User's Guide
39
Advertisement
Table of Contents
