AEG BPK842720M User Manual page 40

40 www.aeg.com
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display prompts to set
the Language.
The display prompts to set
the Language.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
Possible cause
The necessary settings are
not set.
The automatic switch-off is
activated.
The door is not closed cor‐
rectly.
The fuse is blown.
The lamp is defective.
There was a power cut lon‐
ger than 3 days.
The demo mode is activated. Turn off demo mode in:
The plug of the food sensor
is not correctly installed into
the socket.
There is an electrical fault.
You left the dish in the oven
for too long.
plate is on the front frame of the oven
cavity. Do not remove the rating plate
from the oven cavity.
Remedy
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Fully close the door.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Replace the lamp.
Refer to "Before first use"
chapter.
Menu / Basic Settings /
DEMO. Activation / deactiva‐
tion code: 2468.
Put the plug of the food sen‐
sor as far as possible into
the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De‐
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.