To Resume Speed; Understanding The Features Of Your Vehicle 137; To Vary The Speed Setting; To Accelerate For Passing - Jeep 2008 Grand Cherokee Owner's Manual

To Resume Speed

To resume a previously set speed, push the "RESUME
ACCEL" lever up and release. Resume can be used at any
speed above 25 mph (40 km/h) for 3.7L, 4.7L, and 5.7L
engines, and 14 mph (23 km/h) for 3.0L diesel engines.

To Vary The Speed Setting

When the speed control is ON, speed can be increased by
pushing up and holding "RESUME ACCEL". Release the
lever when the desired speed is reached, and the new
speed will be set.
Tapping "RESUME ACCEL" once will result in a 1 mph
(2 km/h) (3.7L, 4.7L, 5.7L, and 3.0L Diesel models) speed
increase. Each time the lever is tapped, speed increases so
that tapping the lever three times will increase speed by
3 mph (5 km/h) (3.7L, 4.7L, 5.7L, and 3.0L Diesel
models).

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 137

To decrease speed while speed control is ON, push down
and hold "SET DECEL". Release the lever when the
desired speed is reached, and the new speed will be set.
Tapping the "SET DECEL" button once will result in a 1
mph (2 km/h) speed decrease. Each time the button is
tapped, speed decreases.
NOTE: The Speed Control system has been designed to
shut down if multiple speed control switch functions are
operated simultaneously in order to ensure proper op-
eration. If this occurs, the system can be reactivated by
pushing the speed control switch ON/OFF button and
re-setting the desired vehicle SET speed.

To Accelerate For Passing

Depress the accelerator as you would normally. When the
pedal is released, the vehicle will return to the set speed.
3