Alignment And Balance; Tire Chains - Jeep 2007 Liberty Owner's Manual

260 STARTING AND OPERATING
CAUTION!
Replacing original tires with tires of a different size
may result in false speedometer and odometer readings.

Alignment and Balance

Poor suspension alignment may result in:
• Fast tire wear.
• Uneven tire wear, such as feathering and one-sided wear.
• Vehicle pull to right or left.
Tires may also cause the vehicle to pull left or right.
Alignment will not correct this problem. See your autho-
rized dealer for proper diagnosis.
Improper alignment will not cause vehicle vibration.
Vibration may be a result of tire and wheel out-of-
balance. Proper balancing will reduce vibration and
avoid tire cupping and spotty wear.

TIRE CHAINS

CAUTION!
To avoid damage to your vehicle or tires, observe the
following precautions:
•
Because of restricted chain clearance between tires and
other suspension components, it is important that only
chains in good condition are used. Broken chains can
cause serious damage. Stop the vehicle immediately if
noise occurs that could indicate chain breakage. Re-
move the damaged parts of the chain before further use.
•
Install chains on the rear wheels as tightly as possible
and then retighten after driving about
•
Do not exceed 30 mph (48 km/h).
•
Drive cautiously and avoid severe turns and large
bumps, especially with a loaded vehicle.
•
Do not drive for prolonged period on dry pavement.
•
Observe the tire chain manufacturer's instructions on
the method of installation, operating speed, and condi-
tions for use. Always use the lower suggested operating
speed of the chain manufacturer if different than the
speed recommended by the manufacture.
⁄ mile (0.8 km).
1
2