Jeep 2007 Liberty Owner's Manual page 137

ALL DOORS. This can also be programmed using the key
fob, refer to "Remote Keyless Entry" earlier in this
section.
Train Remote?
Pressing the STEP button when in this display will select
"Yes" or "No."
NOTE: Any time you perform this procedure, it is
necessary to retrain all currently trained key fobs.
To Train Additional Key Fobs (using the EVIC module)
1. Press the MENU button until TRAIN REMOTE? NO is
displayed. Press the STEP button to change to YES. Then,
PRESS A VALID FOB KEY will be displayed. Press either
the "Lock" or "Unlock" button on the current key fob.
2. The next display will say PRESS FOB 2 LOCK &
UNLOCK. Press both key fob buttons simultaneously.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 137
3. The next display will say PRESS FOB 2 UNLOCK.
Press the unlock button on the second key fob.
4. The next display will say FOB 2 TRAINED. At this
point, the procedure can be exited by pressing the STEP,
RESET, or C/T button.
5. Repeat step 2 — 4 to train additional key fobs. A total
of four key fobs can be programmed.
Can also be programmed using the key fob, refer to
"Remote Keyless Entry" earlier in this section.
Sound Horn On Lock?
When this feature is selected, a short horn sound will
occur when the remote keyless entry "Lock" button is
pressed. This feature may be selected with or without the
flash lights on lock/unlock feature. Pressing the STEP
button when in this display will select "Yes" or "No."
Can also be programmed using the key fob, refer to
"Remote Keyless Entry" earlier in this section.
3