Problems And Solutions - LEGRAND In One Céliane 672 56 Manual

Problems and solutions

Problems
The Learn indicator light comes on
for 5 seconds.
The Learn indicator light comes on
for 10 seconds
During learning, the Learn indicator light
stops blinking.
When saving the scenario, the Learn
indicator lights of certain receivers do not
go off.
Impossible to perform the calibration
procedure.
*Examples of a disrupter: electronic transformers, switch-mode power supply.
Cause
Learning is impossible.
The number of transmitters saved is greater
than 32.
If there is no activity, the learning mode
closes after 10 minutes.
The control button was not pressed in the
minute after pressing Learn.
Incorrect communication between the
products.
Blind does not support this function.
53
Solution
Install compatible products
Delete unused scenarios.
Restart the learning procedure.
Check the wiring (connection).
Look for the presence of a disruptive
device (*).
Isolate it with a filter.
Set the product to the factory settings.
Do not perform the calibration procedure
Opening to a preset level is impossible
Product can only be made to Roll Up/Stop/
Roll Down.