Special Tools - Zenoah G260PU-EI Owner's Service Manual

12. Special Tools

Part Name
1 Puller Assy
2 Piston Stopper
3 Rod Assy
4 Hex Wrench
5 Snap Ring Pliers
13. Service Guide
Fig.9
Fig.10
10
Part No. External Appearance
1490-96101
4810-96220
1101-96220
3304-97611
5500-96110
1. REMOVING PISTON PIN (Fig.9)
1) Remove snap rings from both sides of the
piston pin.
2) Engage the rod assy(1101-96220) to the
piston pin and gently tap with a plastic
hammer to push out the pin while holding
piston firmly.
CAUTION
Hard hammering may damage the big end of
the connecting rod.
2. INSTALLING PISTON (Fig.10)
1) Make sure to point the arrow mark on the
piston to the exhaust side.
2) Fit the circlip in the groove so as to face the
end gap below.
CAUTION
Deformed circlip may come off during engine
operation and damage the engine.
Usage
To remove rotor.
To hold crankshaft when
disassembling/assembling
the rotor.
To remove/install piston pin.
For socket screw of
4mm, 5mm and 6mm.
To remove snap ring.