Table of Contents
Advertisement
9.
If the function hand and/or the day
indicator is out of alignment, rotate the
crown to adjust them. Move the function
hand to 12 o'clock and/or the day to the
center of the indicator window.
The movement ranges of the function
●
hand and day indicator are limited when
you rotate the crown. The maximum
left-right movement of the function hand
is 180 degrees in either direction. The
day indicator moves only slightly.
After the function hand and day
●
indicator are in the positions you want,
advance to step 12 of this procedure. If
you are unable to make the adjustments
you want, go to step 10.
10.
Press (B).
Confirm that the day indicator shows "1".
Day indicator
The function hand will move repeatedly
●
while the day setting is being changed.
The function hand may continue to
move for about 20 minutes.
Hand and Day Indicator Movement
l
11.
If "1" is not shown for the day, rotate the
crown until "1" is shown for the day.
Rotating the crown also causes the
●
function hand to move. Move the
function hand to 12 o'clock.
12.
Push the crown back in.
Note
Leaving the crown pulled out for more
●
than approximately 30 minutes without
performing any operation will
automatically cause the adjustment
operation to become disabled. If this
happens, push the crown back in to its
normal position and then pull it out
again to restart the procedure from the
beginning. Pushing the crown in to its
normal position part way through the
alignment procedure will cause the
hands to return to their normal position.
Any alignment you performed up to
that point will be applied.
Watch Operation Guide 5666
Other Settings
This section explains other watch settings you
can configure.
Resetting Watch Settings
This section explains how to return the watch
settings below to their initial factory defaults.
Watch Settings
●
Stopwatch
●
Alarm
●
1.
Enter the Calendar Mode.
Navigating Between Modes
l
2.
Pull out the crown to the second click.
This causes the second hand to move to
12 o'clock.
3.
Hold down (A) for at least 10 seconds until
the second hand performs one full
rotation.
4.
Push the crown back in.
Note
Resetting the watch will also delete
●
information for pairing the watch with a
phone, and unpair them.
Second hand
Crown
Other Information
This section provides non-operational
information you also need to know. Refer to
this information as required.
Summer Time Switching
Connecting with a Phone to Switch
●
After the watch is connected with a phone,
summer time switching of Home City time and
World Time is performed in accordance with
the EDIFICE Connected setting (Auto/ON/
OFF) as described below.
Auto :
After the watch is connected with a phone,
summer time is displayed for the current
location time or World Time when it is within
the summer time period. Otherwise standard
time is displayed.
ON :
The watch always displays summer time.
OFF :
The watch always displays standard time.
Auto Summer Time Switching
●
When the watch is connected to a phone, it is
sent summer time period information for your
Home City. If there is a World Time City
specified with EDIFICE Connected,
information for that city will also be sent. If the
EDIFICE Connected summer time setting is
"Auto", the watch will keep track of the summer
time period and perform summer time
switching automatically, even if it is not
connected with the phone.
Supported Phones
For information about phones that can
connect with the watch, visit the CASIO
website.
https://world.casio.com/os_mobile/wat/
20
Advertisement
Table of Contents
