Table of Contents
Advertisement
To access the local configuration menu on an IP telephone
1
Restart the telephone by disconnecting the power, then reconnecting the power.
After about four seconds, the top light flashes and
2
When the greeting appears, immediately, and quickly, press the four display buttons on
the 2000 series (three on the 2033 model), one at a time, from left to right. These buttons
are located directly under the display.
Press the button sequence within 1.5 seconds; otherwise the telephone does not enter configuration
mode.
Manual Cfg DHCP(0 no, 1 yes)
•
If
configuration mode.
•
If any other message appears, disconnect, then reconnect the power, and try to access the
configuration mode again.
3
Enter the network parameters, as prompted.
As each parameter prompt appears, use the keypad to define values.
Use the * key to enter the period in the IP addresses.
Press OK to move forward.
Table 7
describes the values for each display parameter.
Table 7 IP telephone server configurations (Sheet 1 of 2)
Field
Value
DHCP
0 or 1
If DHCP = 0
SET IP
<IP address>
Chapter 9 Registering Nortel 20XX and 11XX IP telephones
20XX
Description
Enter 0 if your network is not using a DHCP server to dispense
IP addresses. (Partial DHCP)
Enter 1 if your network does use a DHCP server.
If you choose to use a DHCP server rather than allocating static
IP addresses for the IP telephones, skip the remainder of this section.
The set IP must be a valid and unused IP address on the network to
which the telephone is connected.
NORTEL NETWORKS
Display
buttons
appears on the screen, you successfully accessed the
BCM 4.0 Telephony Device Installation Guide
appears on the screen.
2033
63
Advertisement
Table of Contents
