Installation - Taramps DS800X2 Instruction Manual

Installation

CAUTION: All connections to power supply, input and output connectors must be
carried out only with amplifier off.
Recommended wire gauge & fuse
Positive / negative power supply cable ___________________________________ 7 AWG
Output cables wire gauge____________________________________________15 AWG
Remote cable _____________________________________________________
Protection fuse or circuit breaker__________________________________________ 60A
Caution: Using wire gauges below the recommendation will result in power loss and
overheating of wiring.
Check polarity and never reverse power supply cables due to the risk of damage to the
amplifier.
Calculated considering a maximum length of 4m. Distance greater than this, you will need
to increase the cable gauges.
It is compulsory to install protection fuses or circuit breakers as close as possible from
batteries.
Connection example 01
BRIDGED 4
2 2
4 ohms
2 ohms
12V
10mm² (7 AWG)
10mm² (7 AWG)
GND
Note: Required battery bank capacity: At
least 60Ah
POWER
REM
4 ohms
DS800X2 2
2 ohms DS800X2 1
Connection example 02
POWER
BRIDGED 4
2 2
REM
In case of compression driver horns and
Note:
tweeters you must install a passive filter in the
*Illustrative images
positive terminal of the same ones (Consult
transducer's manufacturer manual).
RCA Cable
Taramps
Remote Cable 18 AWG
Head Unit
18 AWG
_
Subwoofer
Woofer
4 ohms
DS800X2 2
2 ohms
DS800X2 1
11