Instructions For Assembly; Handling - Kettler ALPHA RUN 200 Safety Instructions And Information On Use

Instructions for
Assembly
• Ensure that you have received all the parts required (see check list) and that they are undamaged. Should you have any
cause for complaint, please contact your KETTLER dealer.
• Before assembling the equipment, study the drawings carefully and carry out the operations in the order shown by the
diagrams. The correct sequence is given in capital letters.
⚠
W arning! Please note that there is always a danger of injury when working with tools or doing manual work. Therefore
please be careful when assembling this machine.
⚠
R isk! Ensure that your working area is free of possible sources of danger, for example don't leave any tools lying around.
Always dispose packaging material in such a way that it may not cause any danger. There is always a risk of suffocation if
children play with plastic bags!
• The equipment must be assembled with due care by an adult person. If in doubt call upon the help of a second person, if
possible technically talented.
• The fastening material required for each assembly step is shown in the diagram inset. Use the fastening material exactly
as instructed.
• Bolt all the parts together loosely at first, and check that they have been assembled correctly. Then use spanner to final-
ly tighten screws.
• Please keep original packaging of this article, so that it may be used for transport at a later date, if necessary.
• For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of tubing plugs).
• When mounting the product please take the recommended torque information into account (

Handling

• Belt adjustment: The belt adjustment takes place during the belt run at a speed of approx. 6 km/h (possibly less). No
one may run on the belt during adjustment!
• If the strap moves to the right, turn the right adjusting screw clockwise with a socket wrench by a maximum of a quarter
of a turn. Run the belt and check whether it runs properly. Repeat the process until the belt is running straight again.
• If the belt deviates to the left, turn the right adjusting screw counterclockwise with a socket wrench by a maximum of a
quarter of a turn. Run the belt and check the operation. Repeat this procedure until the belt is running straight again.
• Belt straightening: Turn the adjusting screw to the right by max. one turn. Repeat this process on the other side. Check
as to whether the continuous belt slips. If this is the case, repeat the described process once again. Be very careful when
adjusting and straightening the belt. An extreme over- or under-tension may damage the running belt!
= xx Nm).
english 8
EN