GMC 1995 Safari Owner's Manual page 129

Pushbuttons
-
The four pushbuttons let you return to favorite stations. To
set the pushbuttons for up to fourteen favorite stations (7 AM and 7 FM):
1. Tune in the desired station.
2. Push the SET button. "SET" appears in the display for about 5 seconds.
3. Within
the
5 seconds, push one of the four pushbuttons. Whenever you
press that button, the preset station will return.
In addition to the four stations set as above, up to three additional stations
may be preset
on
each band by pressing two adjoining pushbuttons at the
same time. Then do the following:
1. Tune in the desired station.
2. Press the SET button.
3. Within 5 seconds, press any two adjoining pushbuttons at the same
time. (The station will return when the same two buttons are pressed
again.)
To Adjust the Tone
-
Use the levers in the upper middle left corner to set
the bass, midrange, and treble until you get the sound you want. The 60 and
250 levers adjust the bass, 1K is midrange, and 3.5K and 10K control the
treble.
We suggest you start with the center lever (1K) in the midpoint position,
then move the others up until you get the amount of bass and treble you like.
Am-St Button
-
Push the Am-St button when you tune to an AM station
that broadcasts in stereo. Your STEREO light will come on when you're
receiving AM stereo. If you push Am-St and there is no more noise, it
means the station is weak. You'll hear the station better if you don't use
Am-St. Just push the Am-St button again to delete stereo.
To Play A Cassette
Your tape player is built to work best with tapes that are 30 to 45 minutes
long on each side. Tapes longer than that are so thin they may not work well
in this player.
Once the tape is playing, use the upper and lower knobs for volume, balance
and fade just as you do for the radio. A lighted arrow shows which direction
the tape is being played.
Cr02
-
The Cr02 button lets you set the system for the type of cassette
being used. If you are using chrome or metal tapes, push the Cr02 button in.
FWD
-
To rapidly advance the tape, press
4
or in the direction that the
amber arrow points and the tape will rapidly go forward until you press the
STOP-EJECT button lightly.
3-13