Ford 1996 Aerostar Manual page 304

Removing the High-Mount Brakelamp
Bulb
Liftgate models
To remove the brakelamp and bulb:
1. Remove the two screws from the surface of
the lens.
2. After removing the screws, remove the lamp
assembly.
3. Disconnect the high-mount brakelamp wiring
connector.
4. Remove the screw retaining the bulb holder
assembly, pull the bulb holder assembly
away from the lamp, and pull the bulb
straight out of the holder.
To replace/install the brakelamp:
1. Push bulb(s) into bulb holder assembly.
2. Place bulb holder assembly on lamp and
install retaining screw. Tighten screw.
3. Connect the high-mount brakelamp wiring
connector.
4. Position the lamp assembly on the vehicle.
5. Install and tighten the two screws.
6. Apply brakes to confirm the brakelamp is
functional after installing.
326