Table of Contents
Advertisement
3-7-3
Super IO Configuration
Onboard Floppy Controller
Select enabled if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has no
floppy drive, select Disabled in this field. The settings are: Enabled and Disabled.
Serial Port1/Port2 Address
Use this item to allow BIOS to select serial port Base Address
Serial Port2 Mode
The optional settings are: IrDA(1.6 us); IrDA(3/16 bit).
IR Duplex Mode
This item allows BIOS to select full or half duplex for serial port 2(IR Mode).The
optional settings are: Full Duplex; Half Duplex.
IRTX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select transmit pin in a normal condition or inverse the
IRTX(IR Mode).
IrRX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select receiver pin in normal condition or inverse the
IRRX(IR mode).
IR Tx to Rx Delay Select
The optional settings are: No Delay and Reception Delay.
This item allows BIOS to select IR from Tx to RX 4 characters time delay for serial
port2(IR mode)
IR Rx to Tx Delay Select
The optional settings are: No Delay and Transmission Delay.
Parallel Port Address
This item allows BIOS to select Parallel Port Base Address.
AC Loss Auto Restart
The optional settings are: Former-Status; Always-on; Always-off.
27
Advertisement
Table of Contents
