Table of Contents
Advertisement
Floppy Drive
If you enable this item, your system will check all
Seek
floppy disk drives at start up. Disable this item
unless you are using an old 360KB drive.
PS/2 Mouse
If this item is set to Enabled, the onboard PS/2
Support
Mouse port will work. Setting this to Disable turns
off the port.
Password Check
If you have entered a password for the system,
use this item to determine if the password is
required to enter the Setup Utility (Setup) or
required both at start-up and to enter the Setup
Utility (Always).
Boot to OS/2 >
Enable this item if you are booting the OS/2
operating system and you have more than 64MB
64MB
of system memory installed.
Internal Cache
Leave this item enabled since all the processors
that can be installed on this board have internal
cache memory.
System BIOS
If you enable this item, a segment of the system
Cacheable
BIOS will be cached to main memory for faster
execution.
DRAM Driving
Setting the driving current for the used DRAM by
Current
this item. The Auto setting is recommended.
SDRAM CAS
This item determines the operation of the
SDRAM memory CAS (column address strobe).
Latency
We recommend that you leave this item at the
default value. The 2T setting requires faster
memory that specifically supports this mode.
3: BIOS Setup Utility
25
Advertisement
Table of Contents
