Philio Technology Corporation PST07 Manual

Slim Multi-sensor PST07
The multi sensor is a Z-WaveTM enabled device which is fully
compatible with any Z-WaveTM enabled network. This device is a
security enabled Z-Wave Plus product that is able to use encrypted Z-
Wave Plus messages to communicate to other security enabled Z-
Wave Plus products. Z-WaveTM enabled devices displaying the Z-
WaveTM logo can also be used with it regardless of the manufacturer,
and ours can also be used in other manufacturer's Z-WaveTM enabled
networks.
The product supports Over The Air(OTA) feature for the products
firmware upgrade.
This product can be included and operated in any Z-Wave
TM
with other Z-Wave certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
The device adopt the Z-Wave
network system is all made by Z-Wave
network system will have the advantages as below.
TM
500 series chip, when your Z-Wave
TM
500 series devices. The
Concurrent multi-channel support reduces external interference.
•
Add to/Remove from Z-Wave
There are two tamper keys in the device, one is in the back side,
another is in the front side. Both of them can add, remove, reset or
association from Z-Wave
The table below lists an operation summary of basic Z-Wave functions.
Please refer
to the instructions for your Z-WaveTM Certificated Primary Controller to
access the
Setup function, and to Add/Remove/associate devices
Notice: Including a node ID allocated by Z-Wave
"Add" or "Inclusion". Excluding a node ID allocated by Z-Wave
Controller means "Remove" or "Exclusion".
Function
Add
TM
network
Remove
TM
1
TM
Network
TM
network.
Description
TM
1. Have Z-Wave Controller entered inclusion mode.
2. Pressing tamper key three times within 2 seconds
to enter the inclusion mode.
3. After add successful, the device will wake to
receive the setting command from Z-Wave
Controller about 20 seconds.
TM
1. Have Z-Wave Controller entered exclusion mode.
2. Pressing tamper key three times within 2 seconds
to enter the exclusion mode.
Node ID has been excluded.
TM
Controller means
TM
TM