Table of Contents
Advertisement
4 GETTING STARTED (continued)
The battery condition is indicated by a symbol in the top right of the
display (
):
Full symbol (orange) = batteries at full capacity
4
Empty symbol (red, flashing) = batteries at lowest
4
sustainable level
4.3 SWITCHING ON / OFF
To switch on: Press and hold the ON/OFF button until the Elcometer
logo is displayed.
To switch off: Press and hold the ON/OFF button until the screen
goes blank.
Note: The gauge will switch off automatically after 1 minute of inactivity.
4.4 SETTING THE BEEP VOLUME
The gauge beeps each time a measurement is taken. To set the beep
volume:
1
Press the '
é
2
Use the
é
3
Use the
' ' to disregard any changes made and return to the previous
screen.
4.5 SETTING THE SCREEN BRIGHTNESS
The screen brightness can be set to '
adjusted automatically using the gauge's ambient light sensor - or can
be set by the user to suit the measurement conditions. To set the
screen brightness:
1
Press the '
é
2
Use the
é
3
Use the
' ' to set or ' ' to disregard any changes made and return to the
previous screen.
The default setting is ' ' (Auto) .
4
www.elcometer.com
' softkey.
softkeys to highlight '
ê
softkeys to adjust the volume and press ' ' to set or
ê
' softkey.
softkeys to highlight '
ê
softkeys to adjust the screen brightness and press
ê
' and press ' ' to select.
'
(Auto)
- the brightness is
' and press ' ' to select.
R
en-4
Advertisement
Table of Contents
