Reprogramming a Single
®
HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink
" shown earlier in this section.
Resetting Defaults
®
To reset HomeLink
to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
at 1-800-355-3515, or on the Internet at
www.homelink.com.
®
®
using a HomeLink
®
button.
®
®
®
Storage Areas
Glove Box
Open the glove box by pulling the bottom of the
handle upward.
Cupholder(s)
Your vehicle may have cupholders located in the front
and rear floor console or in the fold down armrest, and in
the quarter trim.
Front Storage Area
Your vehicle may be equipped with a center armrest
storage compartment in the front bench seat.
To open it, fold down the armrest and press the latch
handle located at the front of the armrest. Then, let the
lid pop up and swing open.
The storage compartment may have a cassette/compact
disc holder.
2-57