AJAX MultiTransmitter User Manual page 21

Unpair device
Connecting wired detectors and devices to MultiTransmitter
How to connect a wired detector or device
When connecting third-party detectors and devices, do not twist the wires together, but
solder them. The ends of wires of the devices or detectors, which will be inserted into the
integration module terminals should be tinned or crimped with a special sleeve.
removing it from the system.
Two options are available:
Deactivate entirely — the device will not
execute system commands or participate in
automation scenarios, and the system will
ignore device alarms and other notifications
Deactivate lid notifications — the system will
ignore only notifications about the triggering
of the device tamper button
Learn more about temporary
deactivation of devices
Note that the system will ignore only the
disabled device. Devices connected via
MultiTransmitter will continue operating
normally
The system can also automatically deactivate
devices when the set number of alarms is
exceeded or when the recovery timer expires.
Learn more about auto deactivation of
devices
Deletes wired detector or device settings