Replacement Bulbs; Windshield Wiper Blade Replacement - Chevrolet 2005 Corvette Owner's Manual

3. Turn the bulb socket one-quarter turn
counterclockwise and pull it out.
4. Pull the bulb straight out to remove it from
the socket.
5. Push the new bulb in the bulb socket until it snaps
into place.
6. Reinstall the lamp assembly by first lining up the
tabs on the bottom of the lamp assembly with the
tabs in the vehicle, then slide it in.
7. Replace the screw at the top of the lamp assembly.

Replacement Bulbs

Exterior Lamp
Front Parking/Turn Signal
Headlamp, High-Beam
Sidemarker
Stoplamp/Taillamp/Turn Signal
For replacement bulbs not listed here, contact
your dealer.
5-48
Windshield Wiper Blade
Replacement
Windshield wiper blades should be inspected each time
maintenance is performed. See "Wiper Blade Check"
under Scheduled Maintenance on page 6-4 for
more information.
Replacement blades come in different types and are
removed in different ways. For the proper type and
length, see Normal Maintenance Replacement Parts on
page 6-13.
It is a good idea to clean or replace the wiper blade
assembly every six months.
Bulb Number
Notice: Allowing the wiper blade arm to touch the
5702KA
windshield when no wiper blade is installed
H9
could damage the windshield. Any damage that
occurs would not be covered by your warranty. Do
W3W
not allow the wiper blade arm to touch the
3057KX
windshield.
To remove the wiper blade assembly, do the following:
1. Open the hood to gain access to
2. Lift the wiper arm until it locks into
the windshield wipers.
a vertical position.