John Louis Home JLH732 Assembly Instructions Manual page 2

STEP 2 - Attaching The Basket
1. Re-attach slides.
2. Insert plastic clips into glide.
3. Rotate clip & push top to snap clip into lock position.
4. Repeat at all clip locations.
5. Fully extend 1 glide.
6. Place basket onto clips (using 2nd horizontal bar).
7. Fully extend 2nd glide & place basket onto clips (using 2nd horizontal bar).
8. Move basket in & out to ensure glides move freely & are locking into place.
2
UNDER SHELF INSTALLATION
STEP 1 - Attaching Slides To Shelf
Brackets with flanges are used for front position.
Brackets without flanges are used for back position.
1. Place a set of brackets flat side up.
2. Extend glide & move lever to release & separate.
3. Position open end of glide with front bracket & align with screw holes.
4. Secure glide to brackets using 1/4 in. machine screws.
5. Position 2nd set of brackets opposite.
6. Extend glide & move lever to release & separate.
7. Position open end of glide with front bracket & align with screw holes.
8. Secure glide to brackets using 1/4 in. machine screws.
The installed width of the basket including brackets is 26 in. wide.
Make sure the bracket will fit within your desired location.
9. Mark the 26 in. basket width on the shelf rail.
10. Place a slide at the mark with the front bracket flange against the back of
the front rail.
11. Secure the glide with 3/4 in. screws.