Advertisement
Turn over the panel module to place screen faced
S7
down for later assembling.
Take 1pcs LED board and 1pcs middle bezel with
speaker's cover unit, then put the middle bezel unit
into a fixture jip. Tear off the release paper on the
S8
back of the LED board, and then paste the LED
board on the correct position of the middle bezel unit,
then paste 1pcs mylar tape to cover the LED board.
Move the middle bezel unit close to the panel
S9
module unit, then assemble the middle bezel unit
with the front bezel and panel module.
4. Disassembly and Assembly Procedures
Tear off 3pcs gum on the back of the LED cable,
then paste the LED cable on the panel. Take 1pcs
S10
touch board, and tear off the release paper of the
middle bezel, and then paste the touch board on the
correct position of the middle bezel.
Use a Philips-head screwdriver to lock 20pcs screws
S11
for locking the middle bezel unit with the panel module.
(No.1~20 screw size=M3x4, Torque=5
9
10
11
8
14
3
7
6
Take 1pcs camera, 1pcs front cover of the camera,
1pcs rear cover of the camera,1pcs connective cable
and 2pcs rubbers. Connect the cable with the camera
board, then tear off the gum of the camera, and then
S12
paste the camera on th front cover, then paste 1pcs
foam on the cable. Assemble 2pcs rubbers with the
rear cover, then assemble the rear cover with the unit,
then locate the cable into the hook of the rear cover.
camera
camera
front cover
0.5kgfxcm)
±
15
12
16
1
17
13
4
20
18
2
19
5
rear cover
Advertisement
