Advertisement
Use a Philips-head screwdriver to tighten 4pcs
screws for locking the rear cover with the unit. Paste
S22
1pcs label on the specific positions of the rear cover.
(No.1~4 screw size=M4x11; Torque=11
Take a stand base with protective bag close to the
monitor. Fit the two tabs on the upper part of the
S23
stand into the grooves, and then lower the stand so
that the monitor mounting area snaps onto the
stand.
Lift up the monitor to check the gap between the
front bezel and the panel, then provide power supply
S24
and a video signal to the monitor
monitor for functionality check, then turn off the
power, and remove all the cables.
4. Disassembly and Assembly Procedures
1kgfxcm)
±
2
3
1
4
, then turn on the
Advertisement
