Advertisement
Take 1pcs camera board to connect the camera
cable, then locate the camera board to the unit. Use
a Philips-head screwdriver to tighten one screw for
locking the camera board with the camera unit.
S17
Use a Philips-head screwdriver to tighten 4pcs
screws for locking the bracket with the panel, to
tighten 1pcs screw for locking the heat-sink.
(No.1~6 screw size=M3x3, Torque=5±0.5 kgfxcm)
2
6
5
Take 1pcs panel lamp cable to connect the panel
module with the interface board, then locate the panel
lamp cable into the hooks of the middle bezel. Connect
S18
the LED cable, touch cable, camera connective cable
and speakers' cable into the connectors of the board,
then paste 3pcs conductive tapes, 1pcs aluminum foil
and 1pcs acetate tape to fix the cables as the picture.
Take 1pcs joystick key, 1pcs joystick board and 1pcs
rear cover, then assemble the joystick key with board.
Locate the joystick board to the correct position of the
S19
rear cover, then use a Philips-head screwdriver to
tighten 2pcs screws for locking the joystick board with
rear cover, paste 1pcs conductive foam on the board.
(No.1~2 screw size=M2x2.4,Torque=1±0.2kgfxcm)
4. Disassembly and Assembly Procedures
1
4
3
1
Tear off the papers on the back of the cable, and then
fix the joystick cable with tapes. Take 1pcs USB board,
2pcs cable, 1pcs conductive foam. Connect the two
cables to the connectors of the USB board, then paste
1pcs conductive foam on the back of the USB board,
S20
and then locate the USB board into the rear cover.
Use a Philips-head screwdriver to tighten one screw
for locking the USB unit with the rear cover, then fix the
USB power cable with 1pcs PVC tape.
(No.1 screw size=M3x6, Torque=4
1
Move the assembled rear cover close to the panel
unit, then connect the joystick cable and 2pcs Usb
cables to the connectors of interface board. Put
S21
down the rear cover and push the rear cover on the
positions marked as the picture below shown for
mechanisms engagement.
2
±
0.5kgfxcm)
Advertisement
