Advertisement
4.2 Assembly Procedures:
Place a bracket chassis base on a protective
S1
cushion, then stick 3pcs Silicon sheets on the
position as the picture below shown.
Turn over a power board and put the power board
S2
into the bracket chassis.
Take a interface board, connect 1pcs EDP cable and
1pcs camera cable to the connectors of the interface
board, then connect the cable of the power board to
the connector of the interface board. Turn over the
interface board and locate it into the bracket chassis
S3
module. Use a Philips-head screwdriver to tighten
7pcs screws for locking the interface board and
power board with the bracket chassis module.
(No.1 screw size=M4x8, Torque=7.5
No.2~7 screw size=M4x8, Torque=7.5
3
2
4. Disassembly and Assembly Procedures
kgfxcm;
±0.5
kgfxcm)
±0.5
7
5
4
1
6
Take a black mylar, tear off 2pcs gum on the back of
S4
the mylar, then paste the mylar on the specific
position of the bracket.
Panel module preparation: Take out 1pcs panel
module with front bezel from carton, remove the
protective film by tearing off all the tapes of the panel
S5
module, then power on the panel module to examine
the panel surface according to inspection criteria
carefully.
Take 1pcs Dell nameplate, then use a locating fixture
to fix the nameplate to the front bezel of the module,
and then move the whole unit into a laminating
S6
fixture, use the laminating fixture to press the
nameplate with the front bezel of the panel module
firmly attachment.
Advertisement
