Advertisement
Tear off 1pcs acetate tapes and 1pcs aluminum foils
and 3pcs conductive tapes for releasing the cables.
Disconnect the panel lamp cable, LED cable, touch
S7
cable, camera connective cable and speakers' cable
from the connectors of the board, then release the
panel lamp cables from the hooks of the middle bezel.
Disconnect the camera cable from away the camera
board, then use a Philips-head screwdriver to
S8
remove one screw for unlocking camera board with
the camera module.
(No.1 screw size=M3x3, Torque=5±0.5 kgfxcm)
1
Use a Philips-head screwdriver to remove 4pcs
screws for unlocking bracket with panel, to remove
S9
one screw for unlocking the heat-sink.
(No.1~5 screw size=M3x3, Torque=5±0.5 kgfxcm)
2
5
5
4. Disassembly and Assembly Procedures
4
3
Lift up the bracket chassis module and tear off the
1pcs acetate tape, then disconnect the EDP cable
S10
away from the connector of the panel module, then
put the bracket chassis module on a cushion.
Use a Philips-head screwdriver to remove 4pcs
screws for unlocking the speakers with middle bezel,
then release the speakers' cable from the hooks of
S11
the middle bezel, and then release the two speakers
from the probers of the middle bezel.
(No.1~4 screw size=M3x6, Torque=4±0.5 kgfxcm)
1
Tear off tapes for releasing the camera connective
cable, then use a Philips-head screwdriver to
remove 4pcs screws for unlocking the camera
S12
module, and then remove assembled camera unit
and put it aside for later disassembling.
(No.1~4 Screw size= M3x4, Torque=3.5±0.5kgfxcm)
1
4
3
4
2
3
2
Advertisement
