Carrier 40MPHA Service Manual page 44

Indoor Unit Sizes 09K-12K (Electrical Parts) (Anti-static gloves must be worn)
NOTE: Remove the front panel (refer to the front panel removal steps) before disassembling electrical parts.
P o r e c d u e r
1) Cut the ribbon with a shear, then pull
out the coil temperature sensor (T2).
2) Remove the screws (2) used for
the ground connection.
3) Remove the screws (1 for the
electronic cover and 1 for the terminal
cover). Next, remove the electronic box
cover and the terminal cover along
the direction indicated in the image
(on the right side) to remove it.
4) Disconnect the fan motor connector
and the step motor.
44
l l I s u r t t a o i n
Ground Screws
Ribbon
Specifications subject to change without notice.
T2 Sensor
40MPHA-03SM