Table of Contents
Advertisement
DXF-701/701CE Viewfinder
1 BATT indicator
2 TAKE/TALLY indicator
3 REC/TALLY indicators
4 SHUTTER indicator
5 GAIN UP indicator
6 Eyepiece focusing knob
7 Accessory fixing screw hole
8 Tally lamp
Microphone holding screw
Microphone holder
a)
Microphone
a) Not supplied with the optional DXF-701/701CE
1 BATT (battery) indicator (red)
This indicates when the battery capacity is low. (See
page 37.)
Note
When using a camera control unit, this indicator
flashes when you operate the controls, but this is not a
malfunction.
2 TAKE/TALLY indicator (orange)
When using the ClipLink function while shooting, this
indicator lights when the TAKE button has been
pressed to set a Mark IN point and goes out when a
Mark OUT point is set.
TALLY
TAKE
REC
BATT
SHUTTER
GAIN UP
3 REC/TALLY (recording/tally) indicators (red)
• From the time when you press the VTR button on the
lens or camera head, this flashes until recording
starts, then stays on continuously during recording.
• When using a camera control unit, this lights when
the video from this camera is selected.
• This is also used to indicate a fault. (See page 86.)
• The lower indicator can be disabled by menu setting.
(See page 58.)
4 SHUTTER indicator (red)
This lights when the SHUTTER switch is in the ON
position. (If the EVS is selected, the indicator will not
light.)
Eye cup
9 Eyepiece release catch
0 BRIGHT control
!¡ CONTRAST control
!™ PEAKING control
!£ TALLY switch
!¢ Viewfinder connector
19
Chapter 1 Overview
Advertisement
Table of Contents
