Wireless Network Connection Is Unstable On A Mac; Cannot Print Over A Network - Epson ET-2760 User Manual

Table of Contents

• If you are connecting the product wirelessly via EpsonNet Setup and the Wi-Fi icon does not appear lit

on your LCD screen, make sure your product software was installed correctly. If necessary, reinstall

your software.

Note: If you are using a 5 GHz wireless router, set the router to operate in dual band (2.4 GHz and

5 GHz) mode. If your router uses a single network name (SSID) for both the 2.4 GHz and 5 GHz band,

give each band its own network name (SSID) instead, such as Home Network 2.4 GHz and Home

Network 5 GHz. See your router documentation or contact your internet service provider for instructions.

Parent topic:

Related concepts

Uninstall Your Product Software

Wireless Network Connection is Unstable on a Mac

If you connected a device to a USB 3.0 port on your Mac, you may experience wireless network

interference between your product and your Mac.

If you cannot connect to your product over the wireless network or the connection becomes unstable,

move the device connected to your Mac USB 3.0 port further away from your Mac.

Parent topic:

If you cannot print over a network, try these solutions:

• Make sure that your product is turned on.

• Make sure you install your product's network software as described in your product documentation.

• Print a network status sheet and verify that the network settings are correct. If the network status is

Disconnected, check any cable connections and turn your product off and then on again.

• Print a network connection report and check the codes and messages on the report to help determine

the cause of the problem.

• If you are using TCP/IP, make sure the product's IP address is set correctly for your network. If your

network does not assign IP addresses using DHCP, set the IP address manually.

• Make sure your computer and product are both using the same wireless network.

• If network printing is slow, print a network status sheet and check the signal strength. If it is poor, place

your product closer to your router or access point. Avoid placing your product near a microwave oven,

2.4 GHz cordless phone, or large metal object, such as a filing cabinet.

Solving Network Problems

185

Table of Contents