Solving Setup Problems; Noise After Filling The Ink; Software Installation Problems - Epson ET-2760 User Manual

4. Select one of these options:
• Network Settings: Resets all network settings.
• All except Network: Resets all settings except network settings.
• All Settings: Resets all settings.
You see a confirmation screen.
5. Press the OK button to reset the selected settings. (Press the
operation.)
Parent topic:

Solving Setup Problems

Check these sections if you have problems while setting up your product.

Noise After Filling the Ink

Software Installation Problems

Control Panel Setup Problems
Parent topic:
Noise After Filling the Ink
If you hear noises from your product after filling the ink tanks with ink, check these explanations:
• The first time you fill the tanks with ink, the product must charge its print head. Wait until charging
finishes before you turn off the product, or it may charge improperly and use excess ink the next time
you turn it on. Your product is finished charging the print head when the
• If the product's print head stops moving or making noise, and the charging process has not finished
after approximately 20 minutes, turn off your product. Turn it back on and check to see if charging is
still in progress. If it is still in progress, contact Epson for help.
Parent topic:
Software Installation Problems
If you have problems while installing your product software, try these solutions:
• Make sure your product is turned on and any necessary cables are securely connected at both ends. If
you still have problems installing software, disconnect the cable and carefully follow the instructions on
the Start Here sheet. Also make sure your system meets the requirements for your operating system.
Solving Problems
Solving Problems
Solving Setup Problems
stop button if you want to cancel the
180
power light stops flashing.