Network - Fortinet FortiFone FON-C70 User Manual

6. Enter the desired value in the Outbound Proxy1/2 and Proxy Fallback Interval fields
respectively.
7. Press the Save softkey to accept the change or the Back softkey to cancel.
To disable an account via phone user interface:
1. Press Menu > Settings > Advanced Settings (Default password: 23646) > Account.
2. Press the Enter softkey.
3. Press the
4. Press the Save softkey to accept the change or the Back softkey to cancel.
Registering an account is configurable via web user interface at the path Account > Register.

Network

WAN Port
If your phone cannot contact a DHCP server for any reason, you need to configure network
settings manually. The IP phone can support either or both IPv4 and IPv6 addresses.
To configure the IP mode via phone user interface:
1. Press Menu > Settings > Advanced Settings (Default password: 23646) > Network > WAN
Port.
2. Press the
3. Press the Save softkey to accept the change or the Back softkey to cancel.
You can configure a static IPv4 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as IPv4 IP or IPv4 & IPv6.
To configure a static IPv4 address via phone user interface:
1. Press Menu > Settings > Advanced Settings (Default password: 23646) > Network > WAN
Port.
2. Press
3. Press
4. Enter the desired value in the IPv4 Address, IPv4 Subnet Mask, IPv4 Default Gateway, IPv4
Pri.DNS and IPv4 Sec.DNS fields respectively.
5. Press the Save softkey to accept the change or the Back softkey to cancel.
You can configure a static IPv6 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as IPv6 or IPv4 & IPv6.
To configure a static IPv6 address via phone user interface:
1. Press Menu > Settings > Advanced Settings (Default password: 23646) > Network > WAN
Port.
2. Press
3. Press
4. Enter the desired value in the IPv6 IP, Prefix, Default Gateway, Primary.DNS and
Secondary.DNS fields respectively.
5. Press the Save softkey to accept the change or the Back softkey to cancel.
Configuration Overview
or softkey to select Disabled from the Account Status field.
or softkey to select IPv4 IP, IPv6 or IPv4 & IPv6 from the IP Mode field.
to select IPv4 IP and press the Enter softkey.
to select Static IPv4 Client and press the Enter softkey.
to select IPv6 and press the Enter softkey.
to select Static IPv6 Client and press the Enter softkey.
Page 21 FortiFone User Guide