Datatrak Operation; Setup Mode; Run Mode - Graco DataTrak 3A4385B Instructions Manual

DataTrak Operation

The display (AE) will turn off after 1 minute to save
battery life. Press any key to wake up the display.
To prevent damage to the soft key buttons, do not
press the buttons with sharp objects such as pens,
plastic cards, or fingernails.

Setup Mode

1. See F . 5, page 6. Press and hold
IG
seconds until Setup menu appears.
2. To enter settings for system type and flow rate units,
press to change the value, then
the value and move the cursor to the next data field.
• Set system type (AC).
3. More the cursor to the system type field (AC), then
press once more to exit Setup mode.

Run Mode

Prime/Flush
1. See F . 5, page 6. To enter Prime/Flush mode,
IG
press any key to wake up the display, then press
. The Prime indicator will appear in the display
and the LED will flash.
F . 6
IG
3A4385B
NOTICE
for 5
to save
2. While in Prime/Flush mode, the batch totalizer (BT)
will not count. The grand totalizer (GT) continues to
count.
3. To exit Prime/Flush mode, press any key to wake
up the display, then press
symbol will disappear from the display and the LED
will stop flashing.
Counter/Totalizer
1. See F . 5, page 6. The last digit of the batch
IG
totalizer (BT) represents the tenths of gallons or
liters. To reset the totalizer, press any key to wake
up the display, then press and hold
seconds.
• If AC is set to ounces, BT and GT display
ounces
• If AC is set to gallons, BT and GT display
gallons
• If AC is set to liters or cc, BT and GT display
liters.
• If AC is set to cycles, BT and GT display cycles.
2. Press to toggle between flow rate units and
cycles. A letter under the BT display indicates that
both BT and GT are displaying gallons (g), liters (l),
or ounces (oz). The word 'cycles' means both BT
and GT are displaying cycles.
Display
See F . 5, page 6. The display (AE) will turn off after 1
IG
minute of inactivity in Run mode or 3 minutes in Setup
mode. Press any key to wake up the display.
DataTrak will continue to count cycles when the display
is off.
The display (AE) may turn off if a high-level static
discharge is applied to the DataTrak, Press any key to
wake up the display.
Diagnostics
See DataTrak Diagnostic Codes, page 8.
DataTrak Operation
. The Prime/Flush
for 3
7