OttLite J8600C Quick Manual

LED Cone Clip Lamp
J8600C
INS-14-0104 REV032014
ENGLISH

CONGRATULATIONS!

You've purchased the finest in natural lighting technology
with your new OttLite

PRODUCT REGISTRATION FORM

Please complete the enclosed Product Registration Form
and return it today by mail, or register online by going to:
www.warranty.ottlite.com
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packing for use on a horizontal
table.
2. To use on standard table, mount lamp body clip (A)
on the preferred edge of the table.
3. Grasp by flex-neck (B) and back of body clamp,
B squeeze clamp mechanism and slide onto table
edge. Clip must fully touch table surface.
4. Verify the lamp is secure before using.
5. Plug the cord into a standard household 120V AC
outlet.
6. Turn the lamp ON & OFF using power switch (C)
located near plug.
7. To position the shade simply bend the Flex-Neck (B)
as needed to point the light. To avoid damaging the
lamp, DO NOT force the Flex-Neck into a sharp bend.
A
CAUTION!
qualIfIed person In order to avoId a hazard. Indoor use only.
FCC Part 15
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
C
• Connect the equipment into an outlet on a circuit different from that of the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
of product.
This Class B digital apparatus complies with Canadian ICES-003.
aC/DC aDaPtEr
Input: AC 100-240V, 50-60Hz
Output: 13.2V DC 280mA with male DC plug
PL-0016
® product.
If the external flexIble cable or cord of thIs lumInaIre Is damaged, It shall be exclusIvely replaced by the manufacturer or Its servIce agent or a sImIlar
Any change or modification to product not expressly recognized by OttLite Technologies voids OttLite's responsibility for proper function
LED Cone Clip Lamp
SAFETY WARNING: TO REDUCE THE RISK OF
FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
1. Turn off/unplug and WAIT UNTIL BULB / LAMP
HEAD IS COOL before handling.
2. Bulb gets hot quickly! Touch only switch/plug when
turning ON or OFF.
3. Never use with an extension cord unless the plug can
be fully inserted into the receptacles in the extension
cord.
4. Do not alter the plug.
5. The bulb included with this unit cannot be replaced by
the consumer.
Enjoy your OttLite LED Cone Clip Lamp!
®
NOTE: The important safety instructions appearing in
this instruction sheet are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution, and care must
be used with any electrical product.