Manual Transaxle Operation - Chevrolet 1998 Prizm Owner's Manual

Manual Transaxle Operation
5-Speed
I
This is your shift pattern. Here's how to operate
your transaxle:
FIRST (1): Press the clutch pedal fully and shift into
FIRST (1). Then, slowly let up on the clutch pedal as
you press the accelerator pedal.
Keep your foot off the clutch pedal unless you are
operating the clutch. Avoid excessive use of the clutch
in a half-engaged condition, otherwise the clutch could
slip or could cause problems by overheating.
You can shift into FIRST (1) when you're going less
than 20 mph (32
kmk).
If you've come to a
complete
stop and it's hard to shift into FIRST (1)' put the shift
lever in NEUTRAL (N) and let up on the clutch. Press
the clutch pedal back down. Then shift into FIRST (1).
SECOND (2): Press the clutch pedal
as you let up on
the accelerator pedal and shift into SECOND (2). Then,
slowly let up on the clutch pedal as you press the
accelerator pedal.
THIRD (3), FOURTH (4), FIF
3
(5): Shift into
THIRD (3)' FOURTH (4) and FIFTH (5) the same way
you do for SECOND (2). Slowly let up on the clutch
pedal as you press the accelerator pedal.
To stop, let up on the accelerator pedal and press the
brake pedal. Just before the vehicle stops, press the
clutch pedal and the brake pedal, and shift to
NEUTRAL (N).
2-1s