Chevrolet 1998 Prizm Owner's Manual page 246

3,
4.
Check both sides of the dipstick, and read the lower
level.
The
fluid level must be between the two
dimples
in
the hot range.
If the fluid level is
in
the acceptable range, push the
dipstick back in all the way; then press the tab down
to lock the dipstick in place.
How to Add Fluid
Refer to
the
Maintenance Schedule to determine what
kind of transaxle fluid to use. See "Recommended
Fluids and Lubricants"
in
the Index.
If the fluid level is low, add only enough of the proper
fluid to bring the level into the area between dimples
on the dipstick.
1. Pull out the dipstick.
2. Using a long-neck funnel, add enough fluid at the
dipstick hole to bring it to the proper level.
It doesn't take much fluid, generally less than one
pint (0.5 L). Don't overfill.
NOTICE:
We recommend you use only fluid labeled
DEXRON@-111, because fluid with that label is
made especially for your automatic transaxle.
Damage caused by fluid other than DEXRON-111
~
is not covered by your new vehicle warranty.
3. After adding fluid, recheck the fluid level as
described under "How to Check."
4. When the correct fluid level is obtained, push the
dipstick back in
all the
way; then press the tab down
to lock the dipstick in place.
6-20