laerdal NeoNatalie Quick Start Manual

NeoNatalie Resuscitator
Reprocessing instructions
1. Product Overview
To disassemble, follow steps 1-7. To reassemble, follow the steps in reverse.
4
4
Unscrew
4
4
4
Patient Valve Housing
upper part
5
3
3
3
Take Out
3
2
2
2
3
Unscrew
2
2
Mask No. 1
+ enjuague
+ rinse
en agua
in clean water
3 x 1 minutos
3 x 1 minute
1
1
1
1
1
Pull Off
1
Also included:
Mask No. 0
3.Testing before Use
1. Lip Valve function
°C
+ rinse
OR
utes Disinfect
in clean water
60 minutes
3 x 1 minute
Squeeze the bag. Check that the Lip Valve
Membrane valve opens and closes with every
squeeze.
If any of the above tests fail, dismantle NeoNatalie Resuscitator, inspect the components, reassemble and repeat the complete procedure in 3. Testing Before Use.
Remove damaged parts from use.
Pressure
4
Release Valve
+ rinse
in clean water
3 x 1 minute
5
5
5
Pull Out
5
5 2. Cleaning and Disinfection Procedure
Lip Valve
Membrane
1. Immediate
Pre-Cleaning
Wipe and clean
the outside of the
Patient Valve
lower part resuscitator with a piece
of clean gauze soaked in
0.5 % chlorine solution.
Patient Port
Connector
1. Choose one of the following disinfection methods:
100 °C
Disinfect
Autoclaving in clean water
60 minutes
10-20 minutes
Steam 136 °C
Steam 136 °C
10-20 minutes
10-20 minutes
Steam 136 °C
OR
10-20 minutes
Disinfect
60 minutes
1. Inspection
Visually inspect each
part for damage and
cleanliness / mineral
deposits.
Remove damaged or
unclean parts from
service.
2. Pressure Release Valve
Steam 100 °C
OR
10-20 minutes
Seal the mask with a hand. Squeeze the bag
forcefully. Check that air is released from
the Pressure Release Valve.
6
Self-inflating
Ventilation Bag
Inlet Valve
Disk Membrane
6
+ enjuague
+ rinse
Disinfect
+ enjuague
+ rinse
en agua
in clean water
60 minutes
en agua
in clean water
3 x 1 minutos
3 x 1 minute 60 minutes
+ enjuague
3 x 1 minutos
3 x 1 minute
Disinfect
en agua 7
60 minutes
3 x 1 minutos
7
+ enjuague
+ rinse
in clean water en agua
3 x 1 minutos
3 x 1 minute
2. Disassembly
Always dismantle
before cleaning.
Chemical
Activated glutaraldehyde 2.4%
+ rinse
OR + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse + rinse
Disinfect
OR
Disinfect OR
Steam 136 °C
in clean water
+ rinse
60 minutes
in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water in clean water
OR
10-20 minutes Disinfect Steam 100 °C
60 minutes + rinse
3 x 1 minute in clean water
OR
60 minutes
3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute 3 x 1 minute
10-20 minutes
in clean water 3 x 1 minute
Steam 100 °C
3 x 1 minute
10-20 minutes
Follow chemical
manufacturer's instructions
Descaling
If parts become
coated in limescale
immerse equal parts
of water and white
Steam 136 °C
10-20 minutes
vinegar (3-5%) for
10 minutes. Rinse in
clean water. Repeat if
necessary.
3. Inlet Valve opening
Keep the mask sealed against hand. Release the
squeezed bag. Check that the bag re-expands
without resistance.
Inlet Valve
6
6
Pull Out
6
6
+ rinse
in clean water
3 x 1 minute
100 °C
100 °C
in clean water
Disinfect
in clean water
10-20 minutes
7
100 °C
10-20 minutes
7
in clean water
7
Pull Off
10-20 minutes
7
Inlet Valve Housing
Caution: Do not disassemble parts beyond the steps shown.
100 °C
Disinfect
in clean water
60 minutes
+ enjuague
+ rinse
10-20 minutes
Disinfect
en agua
in clean water
60 minutes
3 x 1 minutos
3 x 1 minute
Pre-disinfection
4. Rinsing after
3. Manual Cleaning
cleaning
Rinse parts
Wash all parts in
a clean tray with thoroughly in clean
water to remove all
clean water and
mild soap. Use a soil and soap.
scrub or brush to
Repeat steps 3-4 until
remove any soil.
parts are clean.
Disinfection
2. Post-Treatment:
Boil or Steam*
1. Remove parts using
aseptic technique.
Steam 136 °C
OR
10-20 minutes Disinfect
60 minutes
Steam 100 °C
Steam 100 °C
OR
10-20 minutes
10-20 minutes Steam 100 °C
OR
10-20 minutes
*Validated at approximately
sea-level pressure
Post Disinfection
2. Reassembly
Reassemble as shown above in
1. Product Overview.
+ rinse
OR
Disinfect
in clean water
60 minutes
3 x 1 minute
+ enjuague
Disinfect
en agua
60 minutes
3 x 1 minutos
Steam 100 °C
Steam 100 °C
10-20 minutes
10-20 minutes
100 °C
Steam 100 °C
in clean water
10-20 minutes
10-20 minutes
5. Post-Treatment
Steam 100 °C
10-20 minutes
Before disinfection,
dry with clean gauze or cloth.
2. Allow parts to cool. Dry each
part with sterile gauze or air dry
in a protected space.
Steam 100 °C
+ rinse
OR
10-20 minutes
in clean water
3 x 1 minute
3. Function Test 4. Storage
See 3. Testing before Use Store in a clean,
below. enclosed space.
Steam 100 °C
OR
10-20 minutes
4. Product sealing
Keep the mask sealed
against the hand. Press
the Pressure Release Valve
down. Squeeze the bag
and check that there is no
leakage.
Page 2
in
10